How To Install American Craftsman 70 Series Windows

seven. Clean the opening of

any debris. Cover any

holes made by the sash

weights, pulleys, easttc.

Remove sometime screen hook

optics or other protruding

fasteners.

8. (If Applicable) Install

the supplied Sill Angle

in the groove on the

bottom of the exterior

of the window (Encounter

Figures 8a, 8b and 8c

to determine

appropriateastward Sill Angle

application). Caulk

forth the bottom of

the sill bending and

where the window

meets the stool.

ix. Caulk the within edge

of the bullheaded cease at the

peak and on both sides of

the opening.

10. (If Applicable)

Install the supplied

Head Expander on the

top of the window.

We recommend that

yous place insulation

between the Caput

Expander and the

window. Apply a bead

of caulk across the top

of the Head Expander.

Attn: Product Registration Department

P.O. Box 6029

North Brunswick, NJ 08902-6029

Identify

Stamp

Here

INSTALLATION INSTRUCTIONS

REMOVE Old WINDOW

REPLACEMENT DOUBLE-HUNG & SINGLE-HUNG WINDOWSouthward

1. With a razor blade

knife, score a line

between the inside stop

and casing. Remove

inside moldings or stops

with wide chisel and

save for later use.

BEFORE YOU STArt:

Read these recommendations, expect at the photos carefully and identify all

pieces to be removed or added during installation.

TOOLS YOU MAY Need:

Broad westwardood chisel, hammer, utility knife, phillips-head screwdriver,

flat-headed screwdriver, level, safety spectacles, gloves, caulking gun, profes-

sional class exterior caulk, drill, 1/eight" drill bit and pliers.

We strongly recommend that you wear protective eyewear and gloves.

Before YOU INSTALL YOUR WINDOW, It IS

IMPORTEmmet THAT YOU DO THE Following:

one. Measure the window opening to ensure that you lot purchased the correct

size window.

2. Measure the window itself to ensure that it volition fit into the desired

window opening. The window should be approximately ane/4" less than

the opening in width and 1/4" to 3/four" less in height.

2. Cords and weights, or

spring balances can and so

exist removed so that the

old bottom westwardood sash

can be removed.

3. Pry out the top and

side parting stops (left

and correct). For stops that

are heavily painted or

stuck you can use a

wide chisel to shear off

the part of the stop that

protrudes into the jamb.

iv. Once the parting

stops are out, the upper

sash can exist removed

from the outer rail.

five. If your existing window

has pre-formed aluminum

tracks, at that place volition be no

wood parting stops on the

sides, simply at that place will be

one at the top. Remove

the pinnacle parting stop and

the staples which fasten

the pre-formed track to

the opening. Once the

staples are removed,

both sash and the tracks

can be removed.

6. Leave the exterior

blind terminate intact. Exercise non

removdue east information technology from the

window frame.

PREPARE THE OPENING

Blind Finish

Exterior Siding

8a

8b 8c

(If Applicable) (If Applicable) (If Applicable)

SL-35 Rev Dvii-10

Source: https://www.manualshelf.com/manual/american-craftsman/70-dh-buck/instructions-assembly-english.html

Posted by: connorsseent1983.blogspot.com

Share this post